Connect USB device to your device
Integrated USB to serial UART interface
Entire USB protocol handled on the chip. No USB specific firmware programming required
Fully integrated 1024 bit EEPROM storing device descriptors and CBUS I/O configuration
Fully integrated USB termination resistors
Data transfer rates from 300 baud to 3 Mbaud (RS422, RS485, RS232) at TTL levels
128 byte receive buffer and 256 byte transmit buffer utilising buffer smoothing technology to allow for high data throughpu
FTDI’s royalty-free Virtual Com Port (VCP) and Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases
USB 2.0 Full Speed compatible
Low operating and USB suspend current
Low USB bandwidth consumption
Transmit and receive LED drive signals
Integrated +3.3V level converter for USB I/O